Thinkvape MKL200 TC Box Mod
One kit contents:
1*Gift Box Packaging
Chip: ST 200 chip inside
Weight: 142g(Mod only);260g(Full kit).
Battery Type: Dual 18650 batteries
Material: Zinc Alloy,Leather,Carbon Fiber
1, the use of all digital synchronous buck DC-DC conversion system, with a high power conversion efficiency;
2, support constant power, constant temperature control output;
3, support Ni/Ti/SS material atomizer temperature control;
4, using linear charge, up to 2A;
5, the use of 'OLED' display, easy to operate the user.
7, reverse connection protection, overheating protection, short circuit protection, low voltage protection, etc..
Power Down Current
USB Charging Voltage
USB Charging Current
Battery rate request
Over 15C discharge high rate battery
Operation and display
1, for the first time after the power on the LOGO1:.1s display LOGO2.
2, the main interface:
Power: ,less than [100W a decimal, above 100W no decimal, temperature control: ,[C and F automatic switching].
Interface content interpretation:
A, [0.00Ω]: current working resistance;
[0.00V]: current output voltage;
SS]: current mode of operation, POWER: represents power mode, NI: NI temperature control mode, SS: SS temperature control mode, TI: TI temperature control mode;
B, ignition interface, display the actual output power, voltage, temperature;
A, mode switching:
1, fast ignition key three times, the position of the POWER flashing, then by + / key adjustable output mode, 5 flashes without operation automatically exit, or confirm the ignition key to exit;
B, + / - key lock:
1, lock: in the main interface and press the + key 2S; then, according to the single + / - key prompt;
2, unlock: again, while pressing the + and - key 2S to unlock and return to the main interface;
C, temperature control limited power:
1, in the temperature control mode and in the case of +/ press the button 2 times to enter the temperature control mode of regulating power; then according to the +/ interface: the key to adjust the power value of continuous 5S without operation automatically exit or press the ignition key to exit;
D, system locked:
1, in the main interface to quickly switch the ignition button 5 times,it shows , indicating that the whole system after the lock; in the case of system lock and then express the ignition key 5 times, unlock the system.
2, old and new atomizer:
3, charging (actual consumption) and shinealternately; when charging, can not work; PS: optimal use two of the same brand, the same capacity of the battery; when the two battery is not the same, will cause the discharge rate is not the same, and charging, need to balance, will increase the charging time.
4, press any key, if there is no operation in the continuous 5S, the screen brightness will be reduced, press any key to restore the display brightness, if there is no operation in the continuous 30S, will extinguish the screen and enter the dormancy.
E, Stealth mode:
While power locked, holding the fire and down buttons simultaneously for five seconds will switch to stealth mode. In this mode the display is off. It will still show error and lock messages. To switch back to normal display mode, hold down the fire button and down buttons simultaneously for 5 seconds. This setting is stored to internal flash memory, and remains if power is removed.
F, The direction switching of screen display
While power locked,holding the fire and up buttons simultaneously for five seconds will change the direction of screen display,hold down the fire button and down buttons simultaneously for 5 seconds can make it recovery.
Protection and warning
:No atomizer or resistance greater than 9.9;
:When the output voltage of the battery is too fast (1, the battery mass discharge rate difference, 2, the current battery power is not enough to support the current power output, the output of the short circuit 3 ;
:The battery voltage is less than 6.4V, which will be shut down quickly to protect the battery;
:Board temperature control is too high.